I have done it many times it is not hard to do. Just make two rows of round bales. I usually did twenty bales at a time. Dig a shallow trench on each side and the ends of the bales. Lay a sheet of plastic over the bales pull it tight and bury the edge in the trench. On one end in the middle stick your anhydrous hose under the plastic. Try to push it as close to the middle as you can. Cover it and the edge of the plastic with dirt. Open the valve on the anhydrous. I usually left it open for a few minutes. Then just pulled it out from under the plastic. One person pulling and another keeping the dirt on the plastic. If you don't need to return the tank just leave the hose there until you open the plastic in a few days toa week. You usually loose very little of the gas. I would then let them set for a week. When you would open the plastic there would be very little anhydrous smell. The cattle would really eat it. Just make sure they have plenty of water. They need a larger amount when eating the treated hay/straw.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Harvestin Hay: The Early Years (Part 2) - by Pat Browning. The summer of 1950 was the start of a new era in farming for our family. I was thirteen, and Kathy (my oldest sister) was seven. At this age, I believed tractor farming was the only way, hot stuff -- and given a chance I probably would have used the tractor, Dad's first, a 1936 Model "A" John Deere, to go bring in the cows! And I think Dad was ready for some automation too. And so it was that we acquired a good, used J. I. Case, wire tie hay baler. In addition to a person to drive th
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.