Posted by Janicholson on July 10, 2012 at 10:19:28 from (199.17.55.151):
In a "A" circuit system, the field is externally grounded by the VR or Charge control switch. It gets its power from attachment to the arm (hot) brush inside the gen, or from a third brush picking up electricity (a little remotely) from the commutator segments. Thus when the bat to gen (or arm) jumper is used the field gets current through their windings. This creates residual magnetism in the iron of the field poles. In a "B" circuit system, the field is grounded inside the generator directly to the case. The field terminal is provided with voltage from the regulation system (not grounded at all). Thus polarizing a B circuit requires flashing the Bat to the F terminal. Momentarily energizing the Field coils to make residual magnetism of the correct magnetic polarity.
Polarizing improperly can and will ruin regulator control components, or not do anything. Jim
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Hydraulics - The Basics - by Curtis Von Fange. Hydraulics was one of the greatest inventions for helping man compound the work he can do. It’s amazing how a little floor jack can lift tons and tons of weight with just the flick of a handle. What’s even more amazing is that all the principals of hydraulic theory can be wrapped up in such a small package. This same package applies to any hydraulic system from the largest bulldozer to the oldest and smallest tractor. This short series will take a look at the basic layout of a simple hydraul
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.