Posted by ericlb on June 09, 2012 at 04:37:30 from (75.107.64.57):
In Reply to: john deere mower posted by 766ih on June 08, 2012 at 21:03:27:
the only way to tell is pull the part with the bad bearing, if its a spindle you should be able to buy a bearing, if you can see the number on the bearing a good auto parts store can get it, if they dont have it already most of these use a common bearing, if its on a idler wheel it may still be available but its going to be a lot harder to change, most are made by riviting 2 stamped halves togeather, with the bearing inbetween the halves, youll have to drill out or grind off the rivits taking great care not to damage the stamped steel pulley at all, replace the bearing, then using grade 8 bolts that are exactly the same diameter as the hole in the pulley and as short as possible, while allowing the nut to fully engauge the threads on the bolts [ use locknuts this is critical] put the 2 halves back togeather, keep in mind that if the old bearing has steel seals over the balls you must use the same style, plastic seals may melt from heat
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - New Life for an Old Allis - by Tyler Woods. My friend Jon, has an old '39 Allis Chalmers B. He thought it a marginal tractor that had long since served its time. She smoked terribly and never had much power but he couldn't afford another so he was limping along with what he had. Jon's Allis has a small front loader and though it doesn't carry much, it serves his needs. It was the hard starting and low power that made him think it was time to replace the old girl. Jon called me to help him discover why his tractor wouldn't start
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.