Posted by holt_2ton on May 11, 2012 at 13:28:57 from (72.11.8.85):
Trying to rebuild one of the main lift cyl. on my "64 Ford 4000 loader(Wagner-Superior). It is a single acting WELDED cylinder. I got the packing nut off the end and the stack-up of packings out. BUT, I cannot get the snap ring out of the bore. It"s about 2" down and does not have any way to pry one of the ends down/out. The ends are square cut and no other notches anywhere else. The end nut compresses the packings against this snap ring and gland that it holds in place. I tried to push this gland back but it won"t budge. Which makes sense because the packings are compressing against this and so there has to be a shoulder there that won"t allow it to move any further in. Also, the way this ring is in there it is somewhat captured by this gland. Is this a non-serviceable unit? HELP!!
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - George's Fordson Major - by Anthony West (UK). This is a bit of a technical info to add on to the article about George's Major in the "A Towny Goes Plowing" article. George bought his Major from a an implement sale about 18 years ago for £200.00. There is no known history regarding its origins or what service it had done, but the following work was undertaken by Harold alone to bring it up to show standard. From the engine number, it was found that the major was produced late 19
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.