Posted by greygoat on May 07, 2012 at 06:17:21 from (69.179.77.180):
In Reply to: hydraulics for dump posted by Joel59 on May 07, 2012 at 05:37:33:
Unless you have a special cylinder, made for the porpose, the "Rod end" of the cylinder doesn"t have enough oil to fully raise the larger displacement, "piston end" to it"s full stroke. On almost anything but a special built hydraulic valve, you"ll have 4 ports, an inlet, a return, and 2 work ports. Oil goes to eather work port depending on handle position. a "three way valve" may have 1 work port blocked, or, not used, so when the control handle goes 1 way, a cylinder extends,when handle goes the other way, a cylinder retracts...that is..the weight of the dump box push"s it down, but the oil returns to te reservior, or tank, out of the return port. how to get the oil to go back into the bottom,or piston end of the cylinder, and let the pump suck from that port also, is your problem, maybe you need some check valves in the circuit.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Harvestin Hay: The Early Years (Part 2) - by Pat Browning. The summer of 1950 was the start of a new era in farming for our family. I was thirteen, and Kathy (my oldest sister) was seven. At this age, I believed tractor farming was the only way, hot stuff -- and given a chance I probably would have used the tractor, Dad's first, a 1936 Model "A" John Deere, to go bring in the cows! And I think Dad was ready for some automation too. And so it was that we acquired a good, used J. I. Case, wire tie hay baler. In addition to a person to drive th
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.