Posted by Jim Ed Love on April 04, 2012 at 20:52:59 from (98.22.69.162):
In Reply to: Re: Ram lost 5th Gear posted by Janicholson on April 04, 2012 at 19:06:39:
Fixed mine that way after the orginal nut backed off and then put on one of the new improved nuts and had it back off after 20,000 mile. Went and got another new and improved nut, put it on and took the first improved nut and run it up for a jam nut then spot welded it on four places opposite one another with a mig. That was 75,000 mile ago and I believe she is gonna hold. Some say not to fix it this way cause it throws the mainshaft out of balance but I have not noticed any vibes in the tranny. Poor folks got poor ways but it worked for me.
Not a bad job to do. Took me longer to drop the driveline and carrier bearing than to pull back case off and put the nuts on, mine was not a four wheel drive though.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - New Life for an Old Allis - by Tyler Woods. My friend Jon, has an old '39 Allis Chalmers B. He thought it a marginal tractor that had long since served its time. She smoked terribly and never had much power but he couldn't afford another so he was limping along with what he had. Jon's Allis has a small front loader and though it doesn't carry much, it serves his needs. It was the hard starting and low power that made him think it was time to replace the old girl. Jon called me to help him discover why his tractor wouldn't start
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.