I designed trusses for 18 years for a local truss company. I say designed what I mean is I input the information and the truss plate manufacturers software analyzed it. Then it was sent to the engineering department for them to stamp. Around here the building departments WILL NOT let you build your own trusses. What grades of lumber you use has as much to do with the strength as the webs do. Most lumber yards do not carry much stress rated lumber, #1 or #2 etc. Standard and better grade is what most carry and is not allowed in the chords of the truss. Stud grade or better can be used for webs though. I don't know if a truss company would sell you the truss plates if they knew what you were doing with them. I don't know where their liability ends where they would not have built the trusses. Simpson Strong Tie makes a plate that looks like a truss plate but it is stamped NOT FOR TRUSSES right on the plate. They don't want the liability either. Part of the price covers the engineering on the trusses. I have done many repairs on trusses that were damaged some how. The little truss plate would be about a 12" x 12" plywood gusset with a pot load of nails in it. The engineers won't allow you any value for adhesive because they can't control how that is applied, only nails or screws(not grabber type screws either, they are too brittle and have no shear strength). The decision is yours alone so be careful whichever you do.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - George's Fordson Major - by Anthony West (UK). This is a bit of a technical info to add on to the article about George's Major in the "A Towny Goes Plowing" article. George bought his Major from a an implement sale about 18 years ago for £200.00. There is no known history regarding its origins or what service it had done, but the following work was undertaken by Harold alone to bring it up to show standard. From the engine number, it was found that the major was produced late 19
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.