Posted by in-too-deep on February 20, 2012 at 09:01:43 from (174.253.144.187):
Power company is going to move a pole and replace the pole that my power is ditributed from. Right now it feeds 100A to the house, a small 120v circuit to the barn, and a small 120v to a receptacle in the yard, and I would eventually put power to the chicken coop; another small 120v. Would use 20 amp breakers for each outbuilding run. They're going to give me a 200 amp meter base, and directly below that, I would install an outdoor breaker panel with a main disconnect, and a breaker for the house, and one for each outbuilding.
How big does my outdoor panel need to be? Can I use a 200A panel if I put a 200a breaker in it plus 3-20a ones?
Would then run a new undergound service to the house with 4/0-4/0-4/0 URD cable and install a new 200a load center in the house. House is 75 feet from pole. I know I need a ground rod at each building.
I am going to consult and possibly hire and electrician for this work, and it will happen under the supervision of the power company crew that does the new pole. Just wanted to get the basics figured out first. Thank you very much for your input, and I know this is covered on here often, so thank you for letting me beat a dead horse.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - George's Fordson Major - by Anthony West (UK). This is a bit of a technical info to add on to the article about George's Major in the "A Towny Goes Plowing" article. George bought his Major from a an implement sale about 18 years ago for £200.00. There is no known history regarding its origins or what service it had done, but the following work was undertaken by Harold alone to bring it up to show standard. From the engine number, it was found that the major was produced late 19
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.