Posted by Christos on February 08, 2012 at 07:01:22 from (64.134.171.91):
Morning everyone,
I was off Monday and decided to see if I could try and figure out the why my tractor (67 Gas Deluxe w/ Z145) would idle well but cut out at Higher RPM's.
I was able to get the choke all the way in at times but generally I had to leave it halfway out and the throttle lever halfway as well. The carburetor's main needle was set at the manual 1 1/2 turns out.
I got into my field and as I was heading home the tractor cut out and I started to do the idiot checklist. I had an extra condenser so I replaced it, cleaned the sediment bowl, there was some slight crud where the gas flows into the bowl from the tank, removed that and it seemed to run better. At times the RPM's on the tachometer seemed surge to a max of 2200RPM and settle down to 1100-1500 RPMs.
There were two things I did notice, the throttle lever did seem to move by itself. I'm about to order the cork and thrust washer and replace them, the other was that when I re-installed the sediment bowl, I had to let the bowl hang and fill with gas and then tighten the knob. Does this mean that my gas cap is faulty and potentially restricting gas flow?
Here is also some video shot with my phone demonstrating what it's doing.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Hydraulics - The Basics - by Curtis Von Fange. Hydraulics was one of the greatest inventions for helping man compound the work he can do. It’s amazing how a little floor jack can lift tons and tons of weight with just the flick of a handle. What’s even more amazing is that all the principals of hydraulic theory can be wrapped up in such a small package. This same package applies to any hydraulic system from the largest bulldozer to the oldest and smallest tractor. This short series will take a look at the basic layout of a simple hydraul
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.