Posted by Mark - IN. on February 07, 2012 at 18:35:40 from (71.57.60.102):
In Reply to: Douglas fir beam posted by Brad Buchanan on February 07, 2012 at 12:16:08:
I'm going to bet thats probably a pretty good price if you have use for it.
I know of two ocassions where wood that big was used recently, both times replacing trusses for barn repair, and both times portable saw mills were brought in to cut what the owners provided. One, white oak, a fella about a half mile from me on a barn that I would have razed it was in such bad sagging shape. Not much longer it would have collapsed on its own. He did quite a repair job. Wouldn't recognize that barn today from what it was. The other one was used to replace one of the trusses in one of five barns on a family farm I almost bought about a decade ago after the parents passed away, and the 6 kids all had their own farms to deal with and didn't have time to work that farm too. That barn was built into a hill with a huge field stone foundation, and that was the ground level from the front side, cattle below on the back side, and those were the size of the two piece trusses that met mid barn to support the first elevated level, and supported a Ford 5000, 4000, and lots of hay bails. But I don't remember what trees they had on property. Don't remember them being oak. I remember that being a real good truss though. Two of the sons proudly showed me every inch since they helped replace it a decade or so before. They did a good job too.
You are looking at a real piece of wood there if you have use for it. If you put it to use, it will probably still be there long after we're both gone. Grin.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Harvestin Hay: The Early Years (Part 2) - by Pat Browning. The summer of 1950 was the start of a new era in farming for our family. I was thirteen, and Kathy (my oldest sister) was seven. At this age, I believed tractor farming was the only way, hot stuff -- and given a chance I probably would have used the tractor, Dad's first, a 1936 Model "A" John Deere, to go bring in the cows! And I think Dad was ready for some automation too. And so it was that we acquired a good, used J. I. Case, wire tie hay baler. In addition to a person to drive th
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.