Posted by LJD on November 06, 2011 at 06:17:17 from (72.171.0.141):
In Reply to: OT - NM-B Wire posted by 61-4010 on November 05, 2011 at 08:47:46:
You're talking #6 copper if using Romex and shooting for a 2% voltage drop..
If I was doing the job, I'd use some version of USE or URD aluminum in conduit. You can go to Home Depot and buy it by the foot, often cheaper then at a wholesale electric store.
I suspect you'll find the #4 aluminum USE or URD "underground service entrance" or "underground residential distribution cable" cable cheaper then #6 UF copper. #4 URD would do the job just fine.
I just installed some underground circuits using 2-2-4 URD cable from Home Depot. Normally it would be $1.08 per foot, but they sold it to me for 60 cents per foot since it was a remnant "end of reel" item. I'm not sure what the 4-4-2 costs right now.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - George's Fordson Major - by Anthony West (UK). This is a bit of a technical info to add on to the article about George's Major in the "A Towny Goes Plowing" article. George bought his Major from a an implement sale about 18 years ago for £200.00. There is no known history regarding its origins or what service it had done, but the following work was undertaken by Harold alone to bring it up to show standard. From the engine number, it was found that the major was produced late 19
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.