Posted by Greg1959 on September 19, 2011 at 09:59:47 from (69.176.13.178):
Just completed a rebuild of a 1957 ford 800 series 172 c.i.d. engine. Installed it on the tractor. I have heard tales of people doing a rebuild and starting the engine and running it while not checking the oil pressure. Then the engine locks up. I do not want this to happen...so I am taking my time. Anyway, No fuel is going to the motor. I am just cranking the engine using the starter. Would this keep me from building up oil pressure? I don't crank too long but the oil pressure gauge does not even budge. I had some old timers tell me that you have to 'prime' the oil pump before starting, after a rebuild. They could not tell me how to 'prime' the oil pump though. Any suggestions? Or should I go ahead and start the engine and keep an eye on the oil pressure and see if it builds?
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - New Life for an Old Allis - by Tyler Woods. My friend Jon, has an old '39 Allis Chalmers B. He thought it a marginal tractor that had long since served its time. She smoked terribly and never had much power but he couldn't afford another so he was limping along with what he had. Jon's Allis has a small front loader and though it doesn't carry much, it serves his needs. It was the hard starting and low power that made him think it was time to replace the old girl. Jon called me to help him discover why his tractor wouldn't start
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.