To get the fluid out, I have had good luck using thin 1/4" hard plastic hose, (Like Pex), that I can fit inside the valve stem. On some tires I have even had to shave the plastic hose down on the O.D. so it will fit in the valve stem. I cut the hose to 5-10" and wrap some tape around the hose about 16" in to seal the hose to the valve stem. Rotate tire so valve stem is up and inflate it with a blow gun. Pull out the blow gun and jab the hose in. The tape on the hose will make a pretty good seal on the valve stem. Rotate the tire so valve is on the bottom.
It may take a while using the tire air pressure to pump the fluid through the 1/4" hose, and probably need to rotate the tire back to the top and re-inflate a couple of times, but when it gets down to the bottom of the tire, I can rotate the tire around and turn the hose back and forth and blow out all the fluid. I think I can remove 99.5% of all the fluid or more and usually it makes very little mess. To refill I have used a 12v sprayer pump. Just be sure to rinse pumps well after use.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Harvestin Hay: The Early Years (Part 2) - by Pat Browning. The summer of 1950 was the start of a new era in farming for our family. I was thirteen, and Kathy (my oldest sister) was seven. At this age, I believed tractor farming was the only way, hot stuff -- and given a chance I probably would have used the tractor, Dad's first, a 1936 Model "A" John Deere, to go bring in the cows! And I think Dad was ready for some automation too. And so it was that we acquired a good, used J. I. Case, wire tie hay baler. In addition to a person to drive th
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.