Posted by gbs on August 20, 2011 at 16:56:29 from (71.54.133.73):
In Reply to: OT Oil Bypass Valve posted by IndianaRed on August 20, 2011 at 13:41:20:
your problem is probably bearing clearance due to mileage ,but on the other hand the oil pumps are bad about wearing out on the newer model engines, we had a couple to start loosing oil pressure replaced the pump corrected the problem ,these had excess of 200k on them, a simple fix for us was to add 2 cans of stp or equivalent to the oil until we could repair them, oil pressure would stabilize were as before it would fluctuate bad when hot,most people have a problem with this method, but years ago i bought a super a tractor to farm with, man told me that the rings and rod bearings had been replaced right before he quit using it not the mains ,needless to say low oil pressure at low engine speeds when hot other than that ran fine ,didn't have the money or time to overhaul it so i poured in 2 cans of stp 4 qts of oil made that crop and several more, its still runs though but it's not used much now
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - New Life for an Old Allis - by Tyler Woods. My friend Jon, has an old '39 Allis Chalmers B. He thought it a marginal tractor that had long since served its time. She smoked terribly and never had much power but he couldn't afford another so he was limping along with what he had. Jon's Allis has a small front loader and though it doesn't carry much, it serves his needs. It was the hard starting and low power that made him think it was time to replace the old girl. Jon called me to help him discover why his tractor wouldn't start
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.