Posted by Bob In SD on July 15, 2011 at 06:27:15 from (137.216.209.99):
I'm hoping Allan or somebody can help me here. Long story short, When I bought my Farmall M about 10 years ago the seller had a grapple hook and cylinder on the Farmhand F-10 loader, and a control valve. He said he had all of the pieces, but had never actually hooked it up. I took the hook and cylinder off and set it aside (I was mainly using it to push snow).
Fast forward to this month, I sold the tractor to a neighbor and he asked if I could help him put the grapple back on and hook it up. The control valve was actually on the tractor when I got it (but the lines running down the side were not hooked to the cylinder). I took it off and moved some things around, but now I don't remember quite how it went.
Could Allan or somebody either take a picture of one that's properly connected or explain it to me? If it would help I could run over to his place and take pictures of what I've got. The previous seller mentioned that all the stuff was there after the haggle was done, so I'm pretty sure most of it was there at one point.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Harvestin Hay: The Early Years (Part 2) - by Pat Browning. The summer of 1950 was the start of a new era in farming for our family. I was thirteen, and Kathy (my oldest sister) was seven. At this age, I believed tractor farming was the only way, hot stuff -- and given a chance I probably would have used the tractor, Dad's first, a 1936 Model "A" John Deere, to go bring in the cows! And I think Dad was ready for some automation too. And so it was that we acquired a good, used J. I. Case, wire tie hay baler. In addition to a person to drive th
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.