If the battery didnt have its polarity reversed and the genny hadnt sat there for a longggggggggggg out of service time I dont see why the genny would have even needed Polarizing in the first place, although it dont hurt.
Its the Genny NOT the VR that needs and gets Polarized but the VR instructions always say to Polarize because if you install a new VR and start her and the genny happened to be at opposite polarity from the battery THEN YOU CAN FRY THE VR
Soooooooooo assuming you didnt change battery polarity and the genny hadnt been theree setting unused for a long timeeeeeeee I DONT SEE FAILUE TO POLARIZE AS THE CAUSE OF NON CHARGING NOW OR FOR TRASHING THE VR
I agree with Jim, MAKE SURE THE VR HAS A GOOD GROUND and check the connection from FLD on VR to the gennys FLD post. Just to be safe go ahead n polarize the genny before re starting.
PS some VR's are polarity sensitive, sure yours is okay for your battery polarity???
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Harvestin Hay: The Early Years (Part 2) - by Pat Browning. The summer of 1950 was the start of a new era in farming for our family. I was thirteen, and Kathy (my oldest sister) was seven. At this age, I believed tractor farming was the only way, hot stuff -- and given a chance I probably would have used the tractor, Dad's first, a 1936 Model "A" John Deere, to go bring in the cows! And I think Dad was ready for some automation too. And so it was that we acquired a good, used J. I. Case, wire tie hay baler. In addition to a person to drive th
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.