Farmall & IHC Tractors Discussion Board |
Cutout Relay or Regulator?
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by George on January 06, 2001 at 15:37:46 from (152.163.195.201):
I read in a previous post that its possible to remove the cutout relay and replace it with a regulator. I have a Cub that the previous owner changed to a regulator instead of the cutout. Though the charging system has never worked since I've owned it. The regulator setup appears to have been wired correctly. It still has the 6 volt positive ground system and I know the generator #1101355 is ok for it charges if I ground the F terminal. The four position light switch powers the lights correctly, but I haven't checked to see if it has higher resistance in the Low position.(Field wire from switch to Gen is disconnected) Any ideas as to what resistance it should read using a decent ohmmeter? Assuming the switch is ok, what would be the better way to go, put a cutout back in or another regulator? Can I use any 6 volt regulator, and just not use the L term, if equipped? Thanks for your help, am learning alot from this site.
Follow Ups:
Home
| Forums
Today's Featured Article -
The Rescue of a Fordson F - by Anthony West. Introduction I live in the UK and have for many years restored Fordson tractors (in the main model N's). I have also restored and shown model F's, E 27N's, Field Marshall Series 2, David Brown Cropmasters and the old rey Fergeson T 20. At one time I had seven restored examples which were shown and used in ploughing matches. As most restorers, I have a number of war stories I can relate on a range of topics that may help other like minded and interested people. Perhaps my first p
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|