Farmall & IHC Tractors Discussion Board |
front rim slipping
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by tony on January 04, 2001 at 15:07:20 from (156.144.109.28):
I just bought a new front tire and tube for my H. I remounted the one piece rim using the three clamps. I had a heck of a time getting those nuts tight enough! After plowing some snow I inspected the tire only to find my new valve stem cut by the clamps from the rim slipping around. Looking at the back side of the casting, there was too much clearance to keep the hex head bolts from turning while tightening up the nut. I figured that square head bolts must go there. But book shows hex head. I also searched the archives and others have had problems too. The only suggestion I could find was to use lock washers on casting side and rim side. Does anyone have any other suggestions for keeping the rim tight and in place? Thanks!
Follow Ups:
Home
| Forums
Today's Featured Article -
The Rescue of a Fordson F - by Anthony West. Introduction I live in the UK and have for many years restored Fordson tractors (in the main model N's). I have also restored and shown model F's, E 27N's, Field Marshall Series 2, David Brown Cropmasters and the old rey Fergeson T 20. At one time I had seven restored examples which were shown and used in ploughing matches. As most restorers, I have a number of war stories I can relate on a range of topics that may help other like minded and interested people. Perhaps my first p
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|