Farmall & IHC Tractors Discussion Board |
Carb does not fit back on
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by RobertN on December 26, 2000 at 20:56:30 from (216.119.28.154):
I just finished putting new floats and a rebuild kit in th ecarb for my '41 A. I tried to set it back on the manifold tonite, but it doesn't fit! When I took it of, it had a stud with a nut on one side(5/16). On the other side was a nut and bolt(1/4). I bought nice new studs to replace the odd bolt. When I went to install it, the studs turned out to be wider than the holes on the manifold. I first check the ears on the carb to ensure they were not bent. then I measured the carb. The holes are 1-1/4" on center. Next I measured the intake; the holes are 1-3/8" on center. Does anyone have any idea's? This is just plain odd! Do I have a wierd mix of intake and carb? The tractor is a '41 A. The carb is a Zenith. It has "B2" stamped on the bottom. On the top is a tag that reads "10850A" I did not see any readily visible marks on the intake. I'm stumped and confused!
Follow Ups:
Home
| Forums
Today's Featured Article -
Repairing A Massey Harris 22 - by John Reeves. I have just given this old girl (boy?) a replacement RH rear axle. I was lucky enough to find an axle in good shape at a reasonable price - also a replacement for the right rear brake assembly which was
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|