Farmall & IHC Tractors Discussion Board |
Re: Re: Re: Re: Re: Re: Re: IH2400 (IH454) metal in hydraulic oil HELP!
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by kirk on December 20, 2000 at 17:15:40 from (216.192.177.43):
In Reply to: Re: Re: Re: Re: Re: Re: IH2400 (IH454) metal in hydraulic oil HELP! posted by ltf in nc on December 20, 2000 at 15:42:15:
That's a good point you would think the metal would sink to the bottom. But, the metal trash is always on the intake side of the filter. I wonder if the pressure relief for the pump is located near the fluid intake for the filter. Hope to find out soon, I've ordered the manuals and when I get them I'll be looking for the fluid flow diagram. Thanks for the ideas.
Follow Ups:
Home
| Forums
Today's Featured Article -
Repairing A Massey Harris 22 - by John Reeves. I have just given this old girl (boy?) a replacement RH rear axle. I was lucky enough to find an axle in good shape at a reasonable price - also a replacement for the right rear brake assembly which was
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|