Farmall & IHC Tractors Discussion Board |
Re: '43 M freeze up, won't roll
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by TJ on December 19, 2000 at 21:13:38 from (209.240.221.94):
In Reply to: '43 M freeze up, won't roll posted by dave keith on December 19, 2000 at 03:58:09:
sounds sounds like water dirt sludge but if allthe things the other guys said to do dont work (hope they do!!!) on the M if a rear axle bearing goes bad and one or more of ball drop down in to rear diff. case there is not enough room between the case and bull gear it will lock it up. And if moving fast it can split the case open on mine it punched it out through housing it was small enough of a hole to be welded up after you have tried the other ideas and if they didn`t help. Jack up rear of tractor and try to spin each wheel by hand first cw and then ccw if the wheel turns one way but not the other or if you can hear metal rub or grind it maybe time for the repair manual under axle bearings HOPE NOT this is the only other idea I had other than what the other guys have already said. good luck Tom
Follow Ups:
Home
| Forums
Today's Featured Article -
The Rescue of a Fordson F - by Anthony West. Introduction I live in the UK and have for many years restored Fordson tractors (in the main model N's). I have also restored and shown model F's, E 27N's, Field Marshall Series 2, David Brown Cropmasters and the old rey Fergeson T 20. At one time I had seven restored examples which were shown and used in ploughing matches. As most restorers, I have a number of war stories I can relate on a range of topics that may help other like minded and interested people. Perhaps my first p
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|