Posted by Patrick HMD on January 12, 2014 at 00:31:09 from (75.0.238.214):
In Reply to: wiring harness posted by Aces on January 10, 2014 at 19:32:40:
jdleach said: (quoted from post at 00:53:49 01/12/14)
Question: Does the above mentioned documentation include the correct and original routing for the wires? There have been some repairs done to my tractor over the years, and I am convinced that the current placement of some wiring is incorrect, and that some of the clips are missing.
Should've seen mine when I first got it. (tractor that is) It was like a bowl of spaghetti. I was amazed that it ran at all.
Well, anyway. Each wire is color coded and lettered or numbered at each end connector. Also included is a list of the same wires telling you exactly what appliance to connect each terminal too. The routing was not hard to figure out. That's how mine came. Simple enough on an 'M' with mag ignition and cutout, not sure about the others.
HTH
Patrick
'49M
This post was edited by Patrick HMD at 00:45:40 01/12/14 2 times.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Uncle Cecil's Super A Lives Again - by Mike Purcell. A week or so out of most of my childhood summers was often spent with my Uncle Cecil and Aunt Sissie in the small East Texas town of Maydelle on their 80 acre farm. Some of my fondest memories of these visits are those of learning to drive a tractor at the helm of Uncle Cecil’s 1948 Farmall Super A. Uncle Cecil was the second owner of this wonderful little tractor, but it was almost as though he had adopted an infant. The original owner was a man from Minnesota who bought her from a local dea
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.