Posted by Janicholson on December 15, 2013 at 16:05:24 from (74.60.94.18):
In Reply to: cub pistons posted by Brandon J on December 15, 2013 at 15:30:44:
If the ridge is at or less than .0035" Diametric change compared to the bottom of the cylinder, removing the ridge with a ridge reamer and glaze breaking with a bead breaker will be doable. If more than this (up to maybe .006) it can be straight honed, and the pistons can be re-sized by Knurling to fit. There are few shops setup to knurl pistons. They will be nervous that they will either break a piston knurling it, or that the job won"t last, or that it will still have piston slap. You might have to sign a waver to get it done. An alternative is to have the block bored out and repair sleeves installed to return it to original diameter. This works well, and is common practice. It is more expensive, but the issue is correctness to keep it in good reliable operation. Jim
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Rescue of a Fordson F - by Anthony West. Introduction I live in the UK and have for many years restored Fordson tractors (in the main model N's). I have also restored and shown model F's, E 27N's, Field Marshall Series 2, David Brown Cropmasters and the old rey Fergeson T 20. At one time I had seven restored examples which were shown and used in ploughing matches. As most restorers, I have a number of war stories I can relate on a range of topics that may help other like minded and interested people. Perhaps my first p
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.