Posted by kopeck on September 09, 2013 at 17:30:17 from (66.243.206.248):
Don't fix what isn't broken right?
So the throttle shaft in the Marvel on my BN is really worn, it still runs OK, not as good as it should have but better then you would expect with that much play. On the shelf I had a Zenith that was freshly rebuilt for a tractor that isn't ready for yet so I figured what the heck, let throw it on.
I bolted it on, syced it up (WOT trottle, WOT on carb, pin slides in freely) and fired her up.
Well, it idles nicely but anything over 1/2 throttle causes some massive surging. Not just a little hunting, like full range of RPM surging, non-stop.
At first I thought it was the carb but if I held the governor shaft steady it ran well.
To sync the carb I had to adjust the yoke on the rod a lot, it surprised me as I was doing it but I figured two different carbs...
I lengthened the rod back out to about where it was on the Marvel and it now doesn't surge but it's really the exact opposite of where it should be (the pin sides in when the carb and the throttle are at low idle). I didn't test governor response but I'm guessing it's not going to be great.
I didn't try the bump spring but isn't that more of a minor correction adjustment?
Everything is moving freely/not binding up.
K
This post was edited by kopeck at 17:32:26 09/09/13.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Rescue of a Fordson F - by Anthony West. Introduction I live in the UK and have for many years restored Fordson tractors (in the main model N's). I have also restored and shown model F's, E 27N's, Field Marshall Series 2, David Brown Cropmasters and the old rey Fergeson T 20. At one time I had seven restored examples which were shown and used in ploughing matches. As most restorers, I have a number of war stories I can relate on a range of topics that may help other like minded and interested people. Perhaps my first p
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.