Posted by pete 23 on September 16, 2012 at 18:27:40 from (74.32.238.2):
In Reply to: starter motor posted by edw on September 16, 2012 at 13:49:49:
That is a job for someone who has done it sucessfully before. It took me a few bungled jobs many years ago to develop a method that works. No one could tell or show me how to do it. I take the field pole shoes out,(marking each one to reinstall in original place) so the coil ends and stud can be cleaned properly. New stud if necessary, new insulators if at all possible, assemble fields and shoes,stud with washers in place but nut not tightened up. Flux it down good, heat stud carefully near threaded end with torch and apply resin core solder . This will heat stud to melt solder without overheating insulators. Then tighten everything down and check for grounded fields. Note also, the field shoes have a longer lip in the direction of rotation.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Rescue of a Fordson F - by Anthony West. Introduction I live in the UK and have for many years restored Fordson tractors (in the main model N's). I have also restored and shown model F's, E 27N's, Field Marshall Series 2, David Brown Cropmasters and the old rey Fergeson T 20. At one time I had seven restored examples which were shown and used in ploughing matches. As most restorers, I have a number of war stories I can relate on a range of topics that may help other like minded and interested people. Perhaps my first p
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.