Posted by El Toro on June 18, 2012 at 14:29:43 from (108.3.225.57):
In Reply to: Super C won't start posted by Smith1000 on June 17, 2012 at 15:57:28:
Your manual should give you the instructions as to what needs to be removed to reach the camgear. A few items will be the hood, grille, radiator to name a few. If the camshaft needs to be removed you need to remove the valve cover, valve levers and shaft assembly, push rods, oil pan and oil pump. Shove the tappets up into their bores to clear the cam lobes. Sort out the parts as they're removed. Use cardboard boxes and write on them what they contain. Don't throw everything into a pile. Take pictures and some video. You'll be glad you did. If the cam gear is stripped pull the camshaft and have it pressed off and a new gear pressed on. Hal PS: Drain the radiator and oil pan.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Uncle Cecil's Super A Lives Again - by Mike Purcell. A week or so out of most of my childhood summers was often spent with my Uncle Cecil and Aunt Sissie in the small East Texas town of Maydelle on their 80 acre farm. Some of my fondest memories of these visits are those of learning to drive a tractor at the helm of Uncle Cecil’s 1948 Farmall Super A. Uncle Cecil was the second owner of this wonderful little tractor, but it was almost as though he had adopted an infant. The original owner was a man from Minnesota who bought her from a local dea
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.