Posted by Mike1972chev on May 14, 2012 at 08:04:49 from (75.149.81.173):
In Reply to: Powder Coating posted by SadFarmall on May 14, 2012 at 05:21:05:
Here is the way I do it.. I would ONLY have small parts that DO NOT see ANY kind of impact.(like a dash panel,trim parts ect) i AM NOT a big fan of powder on a tractor.MOST tractors I know get used and poweder coat IS NOT "bullet proof"like some lead you to belive it is.EXAMPLE: Rear rims,If you scratch,score the powder coating on the rear rims,it is not easy to touch it up like it is paint.I plow with my tractor(and everything else0and I gurantee the rims will get "dinged' from time to time.
GOOD paint looks just as good and is MUCH more easily repairable than powder coat chips.
I have seen powder coated sprint car chassis that have been done,and at the end of the season it looks like someone blasted a shotgun at the under carriage of them!!! The stuff is not the "end all,be all" of coatings.
I do HOWEVER like the high temp ,ceramic coatings on my exaust.Jet Hot rocks!!!
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Uncle Cecil's Super A Lives Again - by Mike Purcell. A week or so out of most of my childhood summers was often spent with my Uncle Cecil and Aunt Sissie in the small East Texas town of Maydelle on their 80 acre farm. Some of my fondest memories of these visits are those of learning to drive a tractor at the helm of Uncle Cecil’s 1948 Farmall Super A. Uncle Cecil was the second owner of this wonderful little tractor, but it was almost as though he had adopted an infant. The original owner was a man from Minnesota who bought her from a local dea
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.