Farmall & IHC Tractors Discussion Board |
47 H
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Dave Sholtis on September 20, 2000 at 16:57:59 from (157.182.212.44):
Hello Again, I started to restore my grandfathers 1947 H yesterday. I'd say that the motor has not been started for the better part of ten years and now the motor will not turn over. I even tried the starter crank with a big pipe wrench to no avail.I know that the tractor was fine when Pap last shut her down (not blown, etc). I have removed the plugs and squirted penetrating oil into the cylinders and now I wait. If when I return, there is still no action, I am considering pulling the tractor in 4ty gear to try and free it up. Is this ok? Do you have any other suggestions short of a teardown? Thanks Dave
Follow Ups:
- Re: 47 H Charlie 17:42:44 09/25/00
(0)
- Re: 47 H Vinegar Desolves Rust! 07:23:40 09/21/00
(0)
- Re: 47 H Brian 05:24:27 09/21/00
(0)
- Re: 47 H Phil Auten (TX) 04:54:02 09/21/00
(0)
- Re: 47 H Bama Binder 20:17:46 09/20/00
(0)
- Re: 47 H john d - Gear 5, a wheelweight, and patience! 19:48:00 09/20/00
(0)
- Re: 47 H Phlogiston 18:02:33 09/20/00
(0)
Home
| Forums
Today's Featured Article -
The Rescue of a Fordson F - by Anthony West. Introduction I live in the UK and have for many years restored Fordson tractors (in the main model N's). I have also restored and shown model F's, E 27N's, Field Marshall Series 2, David Brown Cropmasters and the old rey Fergeson T 20. At one time I had seven restored examples which were shown and used in ploughing matches. As most restorers, I have a number of war stories I can relate on a range of topics that may help other like minded and interested people. Perhaps my first p
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|