Posted by 400D Guy on March 24, 2012 at 12:51:32 from (69.76.146.214):
Well, I was high with expectation, but ---.
History -- I have changed the rear main seal all by myself 3 times. Once, felt. Next, found out that the crank doesn't have the spiral groove, so went with the pricey rubber. Munched it up pretty good trying to install, but mashed it in there the best I could, considering the cost, and called it a day. And, it leaked. Then, split her AGAIN, and went with felt again. Leaked.
So, during the engine rebuild, I instructed the shop foreman to be very understanding of my dilema, and MANY times discussed the seal and how it was about 60% of my concern. He knew very well of my paranoia. Used the rubber again. He said it was difficult to install (paranoia rising)>
Well, I started the 400D first time today, it runs great, starts great on gas, and warmed her up 2 hours. Had the usual diesel fuel leaks, hydraulic leaks, water leaks, but fixed them all. Looked under the tractor, and everything is fine, BUT that +**+ seal is dripping about a drop every 10 minutes.
I'll tell you what -- I never intend to split this nightmare again (gas and diesel pipes, control rods, steering, wiring, hard to access frame to bell housing bolts, on and on). Leaky away buddy.
Does anyone feel sorry for me?
Yes, I'm telling the shop. Maybe they will send someone out to split the stinker for me, and try again. There goes the great paint though.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Rescue of a Fordson F - by Anthony West. Introduction I live in the UK and have for many years restored Fordson tractors (in the main model N's). I have also restored and shown model F's, E 27N's, Field Marshall Series 2, David Brown Cropmasters and the old rey Fergeson T 20. At one time I had seven restored examples which were shown and used in ploughing matches. As most restorers, I have a number of war stories I can relate on a range of topics that may help other like minded and interested people. Perhaps my first p
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.