There is a number on the back of the plate. Using that number and the manual you will be able to determine the intended seed. IH plates will say something like CORN MEDIUM FLAT, CORN LARGE FLAT or PEAS. Drill spacing will be set by switching out internal or external cogs depending on the model of the planter. You will need the manual to figure this out. If no manual you can determine the spacing by experiment rolling the loaded planter over a know distance and counting the seed. If you are going to use this planter to plant garden stuff it is going to plant it too thick anyway and I would suggest a corn plate in one hopper and a peanut or large bean plate in the other. Use the corn plate to plant sweet corn which is small grained. You will tend to plant it too thick but it is easer to thin than to plant by hand. Use the large bean plate to plant anything that has to be thick in the drill such as snap beans.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Repairing A Massey Harris 22 - by John Reeves. I have just given this old girl (boy?) a replacement RH rear axle. I was lucky enough to find an axle in good shape at a reasonable price - also a replacement for the right rear brake assembly which was
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.