Lowell, nice to see your post and I certainly can because it was so simple and very easy to repeat. I was getting ready to move my SMTA tractor into my new heated tractor shed addition I completed this past summer for the winter and the battery needed a charge. The battery being beneath the seat so I removed the forward two bolts which hold the seat in position to the battery box. Hooked up the charger and let it run for a couple of hours while doing something else. After it was charged I flipped the seat up and put one of the hold down bolts back in place finger tight. Jumped up on the tractor to start it and that bolt flew out and the seat with me in it flipped over backwards. I landed on my head and left shoulder breaking several bones along with a big gash on the back of my head. Finger tight is not good enough for that bolt that's for sure. I will never do that again without putting both bolts back in and tightening them up. I just thought maybe the battery needed replacement and would have to remove them again later. I'm guessing my head height would have been about 8 feet above the concrete floor so I'm sure I hit very hard. Glad to be on the road to recovery but still have several months to go with the spinal fracture at L1. My collar bone, shoulder socket and ribs have done well and now trying to get full use of my shoulder again through therapy and my back through exercises. Hope to be fine again this spring sometime, Hal. P.S. You look good in a Santa suit if that was you on the tractor that was posted the other day as "Dad's 1950 Farmall H", Merry Christmas.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Uncle Cecil's Super A Lives Again - by Mike Purcell. A week or so out of most of my childhood summers was often spent with my Uncle Cecil and Aunt Sissie in the small East Texas town of Maydelle on their 80 acre farm. Some of my fondest memories of these visits are those of learning to drive a tractor at the helm of Uncle Cecil’s 1948 Farmall Super A. Uncle Cecil was the second owner of this wonderful little tractor, but it was almost as though he had adopted an infant. The original owner was a man from Minnesota who bought her from a local dea
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
