IF it's a completely broken spindle, I wouldn't weld it either. It of course COULD be done, but the question really is, with the break, if you were to lift the front end up - does will the wheel fall off?
Without too much imagination, you can see where that could become extremely dangerous (the likelikehood of this happening in the field may be slim, but still a possibility. The probability depends on how high up the break is of course).
But in my mind, any scenerio where the wheel could be in a position to drop out would be a situation where you'd REALLY want it to stay in place!
If it is broken in a way that would allow the wheel to fall off - then, it's safe to say if your weld ever broke, the wheel could fall off. So, personally, I'd just go with a new spindle.
If it's broken in a way where the spindle remains secured, but the connection to the steering arm is broken, that's a different story. I'd do whatever welding was required to fix it - just be real careful not to warp the spindle.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Uncle Cecil's Super A Lives Again - by Mike Purcell. A week or so out of most of my childhood summers was often spent with my Uncle Cecil and Aunt Sissie in the small East Texas town of Maydelle on their 80 acre farm. Some of my fondest memories of these visits are those of learning to drive a tractor at the helm of Uncle Cecil’s 1948 Farmall Super A. Uncle Cecil was the second owner of this wonderful little tractor, but it was almost as though he had adopted an infant. The original owner was a man from Minnesota who bought her from a local dea
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.