Posted by Tom Fleming on October 23, 2011 at 03:43:43 from (67.20.249.95):
In Reply to: C lube fill/drains posted by soundguy on October 22, 2011 at 22:31:59:
I have pulled a couple of the front pulley's off, and there are some excellent posts in the archive on this subject.
I use the 8" bearing splitter, with a snap-on heavy duty puller. Works fine using a 1/2" impact wrench. I do heat the pulley shoulder up a bit with the acetylene speed wrench......just don't over do it. Also, you need to pop it "loose" before using the impact wrench. Torque down the puller, and rap the puller center bolt with a couple of moderate blows. Torque some more, then rap again. usually after the 2nd or 3rd iterations of this, the pulley will pop loose.
When it first pops "loose" it will make a sound that causes you to think you've been shot and you will have skid marks in your knickers. These old girls do NOT come off with common 3 jaw gear puller's. Don't even attempt it with one of those. Use a 2 jaw puller, minimally rated 7 tons or more. My puller is rated at 15 tons.
IMHO of course.
This post was edited by Tom Fleming at 17:17:00 10/25/11.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Rescue of a Fordson F - by Anthony West. Introduction I live in the UK and have for many years restored Fordson tractors (in the main model N's). I have also restored and shown model F's, E 27N's, Field Marshall Series 2, David Brown Cropmasters and the old rey Fergeson T 20. At one time I had seven restored examples which were shown and used in ploughing matches. As most restorers, I have a number of war stories I can relate on a range of topics that may help other like minded and interested people. Perhaps my first p
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.