Posted by Scotty HOMEy on October 08, 2011 at 18:02:19 from (70.105.227.205):
In Reply to: Reversing A wheel hubs posted by Stevie J. Mote on October 08, 2011 at 16:23:25:
It does sound right, but reversing may not be necessary, depending on where your wheels are now.
On the A/B/BN series there are 8 possible tread widths in which your rears are in the same configutration on both sides.
Take a look at your rear running gear. Two obvious things to notice. First is that your wheels are dished. Turning that dish in or out on the hub is one big adjustment. The next is that the lugs that bolt the rims to the wheeel are offset (off-center). Choosing which side of the lug to bolt to the wheel is your other big adjustment. So there's four adjustments.
The other four are less readily apparent, and rely entirely on whether the lugs on the rims are bolted to the inside or the outside of the wheels.
The Owner's Manual has a handy chart detailing the tread widths available in each configuration.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Rescue of a Fordson F - by Anthony West. Introduction I live in the UK and have for many years restored Fordson tractors (in the main model N's). I have also restored and shown model F's, E 27N's, Field Marshall Series 2, David Brown Cropmasters and the old rey Fergeson T 20. At one time I had seven restored examples which were shown and used in ploughing matches. As most restorers, I have a number of war stories I can relate on a range of topics that may help other like minded and interested people. Perhaps my first p
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.