Posted by Mike1972chev on September 20, 2011 at 18:00:37 from (99.31.14.38):
Hey guys,
My hydraulic reservoir drips around where the shaft comes out of it on the right side of it.I recently took it apart to clean the tank out and I installed a new o ring,Still dripping slightly.Shaft is just SLIGHTLY sloppy in the bore.(I wonder if I should have took the time and had that hole oversized and installed a bushing????) But what I was wondering where IS the oil level is supposed to be anyway??? Is it supposed to be BELOW that shaft ?Have I been overfilling it all this time? It looks to be kinda hard to put a dipstick on this one because of the 45 deg elbow right at the tank?(I know they make a stick for the "belly"pumps.) My hydraulic system either has to run TWO 3x8 cylinders on my 3 point hitch or ONE 3x8 cylinder on my plow or disk.NEVER all at the same time. I do not wanna EVER run my live pump low!!!(I know they cost from $600.00 to $800.00 bucks !!!
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Rescue of a Fordson F - by Anthony West. Introduction I live in the UK and have for many years restored Fordson tractors (in the main model N's). I have also restored and shown model F's, E 27N's, Field Marshall Series 2, David Brown Cropmasters and the old rey Fergeson T 20. At one time I had seven restored examples which were shown and used in ploughing matches. As most restorers, I have a number of war stories I can relate on a range of topics that may help other like minded and interested people. Perhaps my first p
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.