Posted by Tom Fleming on September 17, 2011 at 17:18:55 from (67.20.249.95):
In Reply to: 48 cub problems. posted by BenB on September 17, 2011 at 14:07:02:
If you followed the timing procedure in the manual, you should be fine. A quick thumbnail is as follows: #1 piston on TDC on the compression stroke. with the mag cap off, make sure rotor is pointing just before #1. mag should slip right on, with the slots lined up. Turn slightly and the impulse should click. tighten her down and you are ready to go.
Like I said, this is a brief thumbnail. If the impulse is clicking twice, then there is an issue in the impulse. Did you try pull starting it? Also, did you have the cam out? You may be timed correctly to the govenor/mag, but is the cam timed right to the crank? Worst case, take the head off, and watch the valves and pistons. Also note the timing mark on the front pulley.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Uncle Cecil's Super A Lives Again - by Mike Purcell. A week or so out of most of my childhood summers was often spent with my Uncle Cecil and Aunt Sissie in the small East Texas town of Maydelle on their 80 acre farm. Some of my fondest memories of these visits are those of learning to drive a tractor at the helm of Uncle Cecil’s 1948 Farmall Super A. Uncle Cecil was the second owner of this wonderful little tractor, but it was almost as though he had adopted an infant. The original owner was a man from Minnesota who bought her from a local dea
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.