Posted by SadFarmall on June 11, 2011 at 04:58:00 from (138.217.75.187):
In Reply to: Ih sickle bar mower posted by restorust76 on June 05, 2011 at 13:41:18:
They are a good mower. I still use a GL-25-VO with 7ft cut behind a Farmall M. It goes out alongside the big disk mower every year. As to the hydraulic cylinder there are at least arrangements for lifting the cutter bar. Either a long rod, which hits you on the elbow, a one way hydraulic cylinder mounted under the tractor and connected via the pulley to lift the cutter bar or a two way cylinder on the mower frame which lifts and lowers the cutter bar. The last arrangement is by far the best for working, but it does have a tendency to break gag levers if not set correctly. Two pictures: one of a 25V behind a Farmall H and the other showing the frame of the mower.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Uncle Cecil's Super A Lives Again - by Mike Purcell. A week or so out of most of my childhood summers was often spent with my Uncle Cecil and Aunt Sissie in the small East Texas town of Maydelle on their 80 acre farm. Some of my fondest memories of these visits are those of learning to drive a tractor at the helm of Uncle Cecil’s 1948 Farmall Super A. Uncle Cecil was the second owner of this wonderful little tractor, but it was almost as though he had adopted an infant. The original owner was a man from Minnesota who bought her from a local dea
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
