Posted by Tony_Idaho on March 30, 2011 at 07:40:56 from (137.201.242.130):
Hello, Not sure if this is a silly question or not. I am needing to remove the entire PTO from my tractor, so I can get to the rear axles. The question I have is... Do I have to take apart the entire PTO? My IT shop manual is assuming I want to do this. I really don't. I was hoping I could remove the entire unit pretty much in one shot, rather than taking each gear out at a time. The PTO looks to have a total of 6 bolts, 4 good size and 2 a bit smaller. I was hoping to just remove them, I think, and kinda wiggle the entier PTO out. I am asuming lots, like it would just shimmy right out... I wasn't really wanting to take apart the PTO, but if that's the way it has to go, I will... Just didn't want to take apart something the wasn't broken and possibly cause leaks... I'm pretty lucky that way...
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Rescue of a Fordson F - by Anthony West. Introduction I live in the UK and have for many years restored Fordson tractors (in the main model N's). I have also restored and shown model F's, E 27N's, Field Marshall Series 2, David Brown Cropmasters and the old rey Fergeson T 20. At one time I had seven restored examples which were shown and used in ploughing matches. As most restorers, I have a number of war stories I can relate on a range of topics that may help other like minded and interested people. Perhaps my first p
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.