Posted by 4020guy on February 08, 2011 at 21:32:43 from (68.171.72.108):
In Reply to: IH 70 Snowblower posted by Spook on February 08, 2011 at 16:46:33:
I'd look for something else like a Lucknow, a Bervac, a Pronovost, a Normand, even an old Mckee. Problem is the output shaft from the gearbox to the fan is only 3 inches long and justs goes into a 2 inch coupling welded onto the fan. It is only held tight with a half inch square key and 2 set screws which don't hold it tight very long. It also has a 3/8's x 4 in bolt through the coupler and the shaft. You can guess the rest, fan starts to move, bolt breaks, fan falls off shaft and gets jammed in the housing. All other blowers's output shaft is at least 12 to 14 inches long and goes all the way through the fan and is held on with a washer and a cap screw. I had a new 80 blower and had trouble with it 2 months after I got it and it was just from snow not blocks of wood, cement blocks, stones, or ag bag plastic, just snow. Good luck Ron
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Rescue of a Fordson F - by Anthony West. Introduction I live in the UK and have for many years restored Fordson tractors (in the main model N's). I have also restored and shown model F's, E 27N's, Field Marshall Series 2, David Brown Cropmasters and the old rey Fergeson T 20. At one time I had seven restored examples which were shown and used in ploughing matches. As most restorers, I have a number of war stories I can relate on a range of topics that may help other like minded and interested people. Perhaps my first p
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.