Possible, yes,likely no. Jack it up, loosen wedge bolt until it starts to force against wedges trying to push them apart. Then turn wheel so key side of axle is down. Strike top of axle at the end with like a four pound hammer. Use lots of penetrating oil. Keep trying to turn bolt and wack it again. If you are lucky the outer wedge will come out, and then you can take a large heavy bar and with a large or larger hammer drive inner wedge out of wheel. If the inner wedge is the one that comes loose first it is really difficult to get enough pop to drive that outside one out. Oh, after one wedge comes loose turn wheel again so wedge is on bottom. That wack on the axle is what will get it's attention though. Before we had the good horse shoe removal tool the wedges were a real problem. All the earliest tractors came with was a pair of large headed pins to hook each end of wedge.Didn't work well. Also, when tightening them, lots of anti sieze and again use the tap on axle to seat wedge, no point in over torquing them as that will only damage threads.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Rescue of a Fordson F - by Anthony West. Introduction I live in the UK and have for many years restored Fordson tractors (in the main model N's). I have also restored and shown model F's, E 27N's, Field Marshall Series 2, David Brown Cropmasters and the old rey Fergeson T 20. At one time I had seven restored examples which were shown and used in ploughing matches. As most restorers, I have a number of war stories I can relate on a range of topics that may help other like minded and interested people. Perhaps my first p
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.