Posted by Zachary Hoyt on November 14, 2010 at 14:27:32 from (184.12.76.221):
In Reply to: soldering a radiator.. posted by mike paulson on November 14, 2010 at 05:57:19:
I poked a hole in one tube in the back of the radiator of my MF35 yesterday. I ran over a pine branch about 1" in diameter while backing up and it somehow poked up in there. I had to remove the radiator and carry it about 3/4 mile through woods and hayfields and over a stream to get it out to the buildings. I used a soldering iron because that was what I had. I pinched the tube shut and cleaned the area carefully, blew it dry with a hair dryer and melted the solder on. My first try leaked a bit when I filled it with water so I soldered again and it was good. I carried the radiator back to the tractor and put it on and it worked fine the rest of the day loading logs and again today with no leaks yet. I think it was just beginner's luck. I used some old lead solder since that was what I had and it was not a potable application. I guess you really do learn something new every day. Zach
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Rescue of a Fordson F - by Anthony West. Introduction I live in the UK and have for many years restored Fordson tractors (in the main model N's). I have also restored and shown model F's, E 27N's, Field Marshall Series 2, David Brown Cropmasters and the old rey Fergeson T 20. At one time I had seven restored examples which were shown and used in ploughing matches. As most restorers, I have a number of war stories I can relate on a range of topics that may help other like minded and interested people. Perhaps my first p
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.