Posted by John T on September 25, 2010 at 06:15:32 from (66.244.97.31):
In Reply to: Farmall 130 Electrical posted by BohemianJon on September 25, 2010 at 05:39:31:
Shes NOT wired correct, maybe one of Bob M's diagrams is close enough to get you by??
One wire from the genny's ARM post should wire to ARM/GEN on a Voltage regulator (or Cutout Relay) and the other wire from FLD post on the genny wires to FLD terminal on a Voltage Regulator. Then the BAT terminal on a Voltage Regulator (or Cutout Relay) wires to an ammeter if it has one, otherwise it would wire eventually to the hot ungrounded battery post often to where the big battery cable attaches to a starter solenoid or switches input.
If the Gennys ARM post is connected to a battery post or battery cable etc THAT WILL DISCHARGE THE BATTERY VERY FAST when shes shut down and the genny get hot THATS VERY VERY WICKED. Theres supposed to be a cutout relay in between ARM on Genny and the battery or ammeter or big cable etc which opens upon shut down.
Get it wired correct and then run my Troubleshooting Orocedure is best I can say for now not knowing what you have there
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Restoring a John Deere 2010 Diesel Tractor - by Jim Nielsen. Following seven years working in California's Silicon Valley, my wife, baby son and I moved back to Australia to retire. We bought a small 'farm' of about 50 acres near Bendigo, in the state of Victoria. I soon found that it would be very useful to have a tractor around the place for things such as grading our long drive and brush-hogging the fields. I was also embarking on planting 1000 eucalyptus trees, and hence I would need a ripper, small disk plow, sprayer etc. to get these things accompli
... [Read Article]
Latest Ad:
1945 Farmall wide body gas with pto and front plow. Runs good but needs new points.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
