Posted by Wardner on September 24, 2010 at 10:02:40 from (4.154.234.134):
In Reply to: Re: IH w4 posted by Harold H on September 24, 2010 at 08:52:52:
I can understand you confusion Harold. I also installed a 2 point on my 650. In that case, I removed the floorboard. Did the same on my 660 and, again, had to remove the floorboard.
On my W-400, I retained the horseshoe drawbar, and attached the Fast Hitch sockets to it with 1" x 3" x 30" flat bars going back to a location near the drawbar hinges.
In my previous post, I used the word "easily". That means the purchase of a ready-made three point hitch. All the tin has to go and secure brackets made for the axle. If designing from scratch, it can be done but the floorboards will limit vertical travel. If one were to use upward sweeping draft arms, he could recapture some of that lost movement.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Rescue of a Fordson F - by Anthony West. Introduction I live in the UK and have for many years restored Fordson tractors (in the main model N's). I have also restored and shown model F's, E 27N's, Field Marshall Series 2, David Brown Cropmasters and the old rey Fergeson T 20. At one time I had seven restored examples which were shown and used in ploughing matches. As most restorers, I have a number of war stories I can relate on a range of topics that may help other like minded and interested people. Perhaps my first p
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.