Posted by Kerwin on September 14, 2010 at 09:30:14 from (192.43.65.245):
I posted this in the implement alley forum, but thought I'd try here as well.
I'm trying to line up the sections and guards on an International 990 mower conditioner after putting on a new knife assembly, new guards, and new wear plates. I've found that that there is too much clearance in places between the sections and guards (about 1/16 in.). I would think to get the correct scissors action the clearance should be less.
So, do I need to shim the guards to close the gap with the section? Or does the cutter bar that everything mounts to need to be straightened somehow?
The operator's manual wants a 0.008 in. clearance between the hold down clips and the sections, so I don't want to pound the clips down and cause binding. The guards are forged and don't take readily to pounding for doing any adjustment.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Repairing A Massey Harris 22 - by John Reeves. I have just given this old girl (boy?) a replacement RH rear axle. I was lucky enough to find an axle in good shape at a reasonable price - also a replacement for the right rear brake assembly which was
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.