Posted by Jim Becker on May 24, 2010 at 07:12:42 from (173.57.149.7):
In Reply to: SC mounted planter posted by Dean Olson on May 23, 2010 at 21:19:25:
I haven't run into this situation first hand. But I am likely to with a planter I am going to try either this year or next. So I'm quite interested in how you solve it.
I'd try some sort of insert to take up some space in the can, but a little different method than Gene suggested. I'm assuming you have a Richmond hopper or similar. The part of the outer edge of the seed plate that is exposed inside the hopper should have seed resting on all of it to minimize planting skips. Try an insert like Gene described, but rather than a hole in the center, cut a crescent shape slot around part of the outside. Orient the slot over the exposed part of the plate and dump your seed into the slot. You may find foam rubber easier to work with than styrofoam.
To minimize skips, you may find that you need to plant at a lower speed than you would with an unmodified hopper.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Rescue of a Fordson F - by Anthony West. Introduction I live in the UK and have for many years restored Fordson tractors (in the main model N's). I have also restored and shown model F's, E 27N's, Field Marshall Series 2, David Brown Cropmasters and the old rey Fergeson T 20. At one time I had seven restored examples which were shown and used in ploughing matches. As most restorers, I have a number of war stories I can relate on a range of topics that may help other like minded and interested people. Perhaps my first p
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.