Farmall & IHC Tractors Discussion Board |
39 A clutch rod?
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Lynn on May 30, 2000 at 06:18:39 from (148.144.81.9):
Another silly question. We just finished replacing the cluth, pressure plate, throw-out bearing on my 39-A. We also had the fly-wheel turned down minutely. Upon restoring her, the clutch rod is at maximum adjustment with no threads left. Clutch works pretty well with about a 2-3 second "spin-down" before stopping. It's also a little noisy. My mechanic thinks that the clutch rod is a little too short because the fly wheel was turned down (he thinks it was turned down before in years past) His suggestion is to weld an extention onto the rod. I would have thought the rod would have had adequate adjustment for maintenance of this type. Any one have similar situation? Your suggestions are greatly appreciated. - Lynn
Follow Ups:
Home
| Forums
Today's Featured Article -
The Rescue of a Fordson F - by Anthony West. Introduction I live in the UK and have for many years restored Fordson tractors (in the main model N's). I have also restored and shown model F's, E 27N's, Field Marshall Series 2, David Brown Cropmasters and the old rey Fergeson T 20. At one time I had seven restored examples which were shown and used in ploughing matches. As most restorers, I have a number of war stories I can relate on a range of topics that may help other like minded and interested people. Perhaps my first p
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|