Posted by pete 23 on April 10, 2010 at 16:15:05 from (173.87.145.42):
In Reply to: bleeding hyd. on 806D posted by Brad in WI on April 10, 2010 at 09:18:14:
Sledge hammer may work, but I think I would take a different route. Take the small plug out on the mcv valve right below the oil cooler lines going to the front, or the plug with a 5/8th head on it right below the transmission oil pressure sending unit. Start it up and rev it up a bit, caution, if it primes oil will come shooting out really fast. Be prepared to shut off quick. If that doesn't work, well, that extra 5 gals may well do the trick. I have also squirted oil in that plug and blew it back in some to get it back into the pump. Or drive the nose down into a ditch. Ideally of course this problem should not happen with a good pump and sealed system.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Rescue of a Fordson F - by Anthony West. Introduction I live in the UK and have for many years restored Fordson tractors (in the main model N's). I have also restored and shown model F's, E 27N's, Field Marshall Series 2, David Brown Cropmasters and the old rey Fergeson T 20. At one time I had seven restored examples which were shown and used in ploughing matches. As most restorers, I have a number of war stories I can relate on a range of topics that may help other like minded and interested people. Perhaps my first p
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.