Bob M said: (quoted from post at 22:23:19 12/04/09) Your recap is right on!
Thanks Bob. I just looked at it a little bit ago and realized it doesn't have a counter weight on it. Just a round quarter inch shaft sticking out with a slot in it and the spring wrapped around it. The end of the spring hooked over a small post sticking out a little below the shaft. The slot in the shaft was almost perpendicular with the ground but at about 9:30 & 3:30 orientation.
Gotta move some hay tomorrow, I'll try a screw driver in the slot to see if it moves and what it does after warmup.
Will the lack of a counterweight affect it? Thanks.
Without the weight the heat control valve will not open properly when warmed up. The spring is of bi-metal construction so that as it gets hot it uncoils. The weight is there to ensure that the valve opens completely.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Rescue of a Fordson F - by Anthony West. Introduction I live in the UK and have for many years restored Fordson tractors (in the main model N's). I have also restored and shown model F's, E 27N's, Field Marshall Series 2, David Brown Cropmasters and the old rey Fergeson T 20. At one time I had seven restored examples which were shown and used in ploughing matches. As most restorers, I have a number of war stories I can relate on a range of topics that may help other like minded and interested people. Perhaps my first p
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.