Posted by ScottyHOMEy on November 03, 2009 at 03:27:26 from (71.241.194.40):
In Reply to: Tight C posted by RalphL on November 03, 2009 at 03:11:20:
I'd sooner suspect poor battery connections or small cables. With everything clean, shiny and bright (don't forget the chassis ground), 6v will turn even a new tight motor quite nicely. Automotive type 4 ga cables are too small, though for 6v. They need to be 2 ga at minimum, though 1/0 is about primo.
If you prefer synthetic oil, it will be fine, but I'd hold off on it and use good old dino oil until you've got the motor broken in, maybe 50 hours or better. The newer car engines that don't require a break-in period can run synthetic from the git-go, but my understanding is that the synthetics actually hinder the seating of new rings and so on in motors that need a break-in.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Uncle Cecil's Super A Lives Again - by Mike Purcell. A week or so out of most of my childhood summers was often spent with my Uncle Cecil and Aunt Sissie in the small East Texas town of Maydelle on their 80 acre farm. Some of my fondest memories of these visits are those of learning to drive a tractor at the helm of Uncle Cecil’s 1948 Farmall Super A. Uncle Cecil was the second owner of this wonderful little tractor, but it was almost as though he had adopted an infant. The original owner was a man from Minnesota who bought her from a local dea
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.