Posted by Tom Fleming on October 16, 2009 at 02:38:06 from (206.193.247.91):
In Reply to: Just a Ring job? posted by TedD17 on October 14, 2009 at 18:39:59:
I agree with most of what has been posted so far. I would take the plugs out, and put some of your favorite "snake oil" into each cylinder (ie. blaster, Kroil, marvel mystery oil, ATF, kerosense, diesel, and on, and on) and let it sit for 1-2 days. Crank it over a bit after the 2 days, and then put the plugs in. Fire it up, and run it getting it up to temp, and keep running it. I think you will find that the rings free up, and you may not have as much "wrong" as you think you do.
Key here is to get it up to temp, and then work it if you can. Rings can stick on engines that sit that are not stuck.
As always IMHO.
This post was edited by Tom Fleming at 02:43:12 10/16/09.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Rescue of a Fordson F - by Anthony West. Introduction I live in the UK and have for many years restored Fordson tractors (in the main model N's). I have also restored and shown model F's, E 27N's, Field Marshall Series 2, David Brown Cropmasters and the old rey Fergeson T 20. At one time I had seven restored examples which were shown and used in ploughing matches. As most restorers, I have a number of war stories I can relate on a range of topics that may help other like minded and interested people. Perhaps my first p
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.